NEC ELECTRA ELITE IPK II - Ring Cycle Setup; Table 2-5 Ringing Cycles

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 179
Description
Use Program 20-15 : Ring Cycle Setup to define the ringing cycles for each ring
type.
Program 20 : System Option Setup
20-15 : Ring Cycle Setup
Level:
IN
Input Data
Item
No.
Incoming Signal Type
Ringing
Cycle
Default
01 Normal Incoming Call on Trunk 1~13 8
02 PBX, CES Incoming Call 8
03 Incoming Internal Call 12
04 DID/DISA/VRS 8
05 DID/DDI 8
06 Dial-In in the E&M Tie Line 12
07 Door Box Ringing for SLT 8
08 Virtual Extension Ring 8
09 Callback 11
10 Alarm for SLT 5
11 VRS Waiting Message Incoming
Call
6
Table 2-5 Ringing Cycles
Number Ringing Cycle
1On
2 On:2.0 / Off:4.0
3 On:1.0 / Off:2.0
4 On:0.5 / Off:0.5
5 On:0.25 / Off:0.25