NEC ELECTRA ELITE IPK II - Selectable Display Messages

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 181
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display
Messages. There are 20 alphanumeric messages, up to 24 characters long. Use the
following chart when programming messages.
Program 20 : System Option Setup
20-16 : Selectable Display Messages
Level:
SA
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, d-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
, Enter characters:
, + , - . / : ; < = > ? B E σ S ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space. (In system programming
mode, use the right arrow soft key instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.