NEC ELECTRA ELITE IPK II - Call Routing Mailbox Options

Document Revision 1 Electra Elite IPK II
2 - 434 Program 47 : In-Mail
Description
Use 47-08: Call Routing Mailbox Options to set the options for mailboxes assigned as
Call Routing Mailboxes in
47-07-02: Routing Mailbox Type.
Program 47 : In-Mail
47-08 : Call Routing Mailbox Options
Level:
IN
Input Data
Item
No.
Item Input Data Default
01
Dial Action Table
(Dial Action Table)
Use this option to assign the Dial Action Table to the
Call Routing Mailbox. The Dial Action Table defines the
dialing options for the call Routing Mailbox.
1~16
(Dial Action
Table 1~16)
1 (Dial Action Table 1)
02
Screened Transfer Timeout
(Scrn Trf Timeout)
Use this option to set how long a Screened Transfer
(TRF) from the Automated Attendant will ring an
unanswered extension before recalling.
This option has a similar function as Customize:
Mailbox Options: Call Routing: [Call Handling] Options:
Delay Rings Before Redirect Transfer in Electra Elite
IPK II In-Mail.
0~255 (sec)
Entering 0
causes
immediate
recall.
15 (sec)
03
Time Limit for Dialing Commands
(Dialing Timeout)
This option determines how long IPK II In-Mail will wait
for an Automated Attendant caller to dial before routing
the call to the Timeout destination.
Be sure your Dial Action Tables have a Timeout action
programmed.
If the caller waits too long to dial:
When the associated Dial Action Table has a Timeout
action programmed, the caller routes to that
destination.
When the associated Dial Action Table does not have
a Timeout action programmed, the Instruction Menu
repeats three times and then IPK II In-Mail hangs up.
0~99 (sec)
Entering 0
causes the
Automated
Attendant to
immediately
route callers to
the Timeout
destination
programmed in
the active Dial
Action Table.
5 (sec)