Electra Elite IPK II Programming Manual 2 - 501
Program
82
Description
Use Program 82-01 : Incoming Ring Tone to set the incoming ring tones, which
are the tones a user hears when a call rings an extension. These tones are
grouped into four ring tone Ranges (1~4), also called patterns, that consist of a
combination of frequencies. (You assign a specific Range to trunks in Program
22-03 and to extensions in Program 15-02.) Within each Range there are three
frequency Types: High, Middle and Low. (Service Code 820 allows users to
choose the Type for their incoming calls.) Each Type in turn consists of two
frequencies and the modulation “played” simultaneously to make up the tone.
These frequencies are determined by their Frequency Number selected in
Items 1 and 2 (see below). In this program, you assign the two Frequency
Numbers and Modulation for each Type, for each of the four Ranges. The
chart below shows the default Frequency Numbers for each Type in each
Range.
Program 82 : Basic Hardware Setup for Extension
82-01 : Incoming Ring Tone
Level:
MF
Input Data
Incoming Ringing Tone Number 1 = Pattern 1 (Trunk Incoming)
2 = Pattern 2 (Trunk Incoming)
3 = Pattern 3 (Trunk Incoming)
4 = Pattern 4 (Trunk Incoming)
5 = Intercom Incoming Pattern
Ringing Tone Type Number
1 = High
2 = Mid
3 = Low
Item
No.
Item Input Data
01
Frequency 1
1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
02
Frequency 2
To Next Page
Loading...
