NEC ELECTRA ELITE IPK II - Incoming Virtual Extension Ring Tone Setup

Document Revision 1 Electra Elite IPK II
2 - 128 Program 15 : Extension, Basic Setup
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a
ring tone range (0~4) to incoming virtual extensions assigned to a Virtual Extension
key (Program 15-07). If you enable ringing for the key in Program 15-09, the key
rings with the tone you set in this program. Also see Program 22-03. The chart below
shows the available tones. There are 256 available extension ports.
Program 15 : Extension, Basic Setup
15-08 : Incoming Virtual Extension Ring Tone Setup
Level:
IN
Input Data
Extension Number Maximum 8 digits
Item
No.
Incoming Ring Pattern Default Description
01
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring
Tone Extension
0: Tone Pattern 1 When an extension or a virtual
extension is assigned to the function
key on the key telephone, select the
ring tone when receiving a call on that
key.
For ACD CAR keys, only tone pattern
1 (entry 0) can be used. The
remaining patterns are not checked
with this feature.