NEC ELECTRA ELITE IPK II - ARS;F-Route Table

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 399
Description
Use Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are 4
kinds of order. If the higher priority trunk groups are busy, the next order group will be
used. If a lower priority route is selected, the caller may be notified with a beep tone.
Program 44 : ARS/F-Route Setup
44-05 : ARS/F-Route Table
Level:
IN
Input Data
ARS/F-Route Table Number 1~500
Priority Number 1~4
Item
No.
Item Input Data Default
01
Trunk Group Number
Select the trunk group number to be used for the
outgoing ARS call.
0~100, 101~150, 255
0 = No Setting
101~150 = Networking
255 = Extension Call
0
02
Delete Digits
Enter the number of digits to be deleted from the
dialed number.
0~255
(255 = Delete All)
0
03
Additional Dial Number Table
Enter the table number (defined in Program 44-06)
for additional digits to be dialed.
0~1000 0
04
Beep Tone
Select whether or not a beep is heard if a lower
priority trunk group is used to dial out.
0 = Off
1 = On
0
05
Gain Table Number for Internal Calls
Select the gain table number to be used for the
internal call (defined in Program 44-07).
0~500
0 = No Setting
0
06
Gain Table Number for Tandem Connections
Select the gain table number to be used for the
tandem call (defined in Program 44-07).
0~500
0 = No Setting
0