NEC ELECTRA ELITE IPK II - DTMF and Dial Tone Circuit Setup

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 17
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CPUII for either DTMF receiving or dial tone detection. The CPUII has 16 circuits
initially. On the Electra Elite IPK II, with additional PGD(2)-U10 ADPs installed, the
system can provide a total of 64 circuits (32 + 32). These are used as follows:
J Extension DTMF receiver for single line telephone
J Trunk DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Conditions
None
Feature Cross Reference
J Caller ID
J Central Office Calls, Placing
J Direct Inward Dialing (DID)
J Direct Inward System Access (DISA)
J Tie Lines
Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
Level:
IN
Input Data
Circuit/Resource Number 01~64
Item
No.
Input Data Default Setting
01
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource 01-08: 1 (Extension Only)
Circuit/Resource 09-32: 2 (Trunk Only)
Circuit/Resource 33-64: 0 (Common Use)