NEC ELECTRA ELITE IPK II - Page 149

Document Revision 1 Electra Elite IPK II
2 - 114 Program 15 : Extension, Basic Setup
06
Extension Polarity Reverse
-- Not Used in U.S. --
Do Not Change Default Entry as DTMF issues
may arise with voice mail.
0 = Disable
(Off)
1=Enable
(On)
0
07
Enabled On-Hook When Holding (SLT)
0=No
1=Yes
1 11-12-45
08
Answer On-Hook when Holding (SLT)
0 = Disable
(No)
1=Yes
(Enable)
1 11-12-46
09
Caller ID Function - For External Module
Enable (1) or disable (0) the Caller ID FSK signal
for an external Caller ID module or a 3rd party
vendor telephone with Caller ID display.
Important:
If voice mail is used, this setting must be
disabled or the system integration codes for
disconnect will be incorrect.
 With some earlier software, if a 2500 set (no
Caller ID) is installed, this must be set to “0”
or else incoming callers will not have a talk
path.
0 = Disable
(Off)
1=Enable
(On)
0
10
Caller ID Name
Determine if an extension user’s telephone
should display the Caller ID name.
0 = Disable
1=Enable
1 15-03-09
11
Caller ID Type
Determine whether the Caller ID type is FSK or
DTMF.
0=FSK
1=DTMF
0
12
--- Not Used ---
13
--- Not Used ---
14
Forwarded Caller ID Display Mode
Determine what the display shows when a
multiline terminal receives a forwarded outside
call.
0 = Calling
Extensio
n
Number
(Calling)
1=External
Caller ID
(Forward)
0
15
Disconnect without dial after hooking hold
Determine whether or not to disconnect a held
call when on-hook without any dialing after
hooking-hold.
0=Normal
1 = Disc.
0
Item
No
Item Input Data Default
Related
Program