NEC ELECTRA ELITE IPK II - Page 246

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 211
06
Permit Code
Table
1
~4
(table)
001
~200
(Entry)
Dial
(Up to 12 digits)
Table 1
~4 = No Setting
This option lets you program the
Permit Code Tables. If the system
has Toll Restriction enabled, users
can dial numbers only if permitted
by these tables and the Common
Permit Table (21-06-04). There are
four Permit Code Tables, with up to
200 entries in each table. The
system permits calls exactly as you
enter the code.
07
Deny Restriction
Table
1
~4
(table)
1
~60
(Entry)
Dial
(Up to 12 digits)
Table 1
~4 = No Setting
This option lets you program the
Restrict Code Tables. If the system
has Toll Restriction enabled, users
cannot dial numbers listed in these
tables. There are four Restrict
Code Tables, with up to 200 entries
in each table. The system restricts
calls exactly as you enter the code.
08
PBX Access
Code
1
~4
Dial
(Up to 2 digits)
Table 1~4 = No Setting
Use this option to enter the PBX
Access Code. When the system is
behind a PBX, this is the code
users dial to access a PBX trunk.
Toll Restriction begins after the
PBX access code. For PBX trunks
(Program 14-04) the system only
Toll Restricts calls that contain the
access code. Always program this
option when the system is behind a
PBX, even if you don’t want to use
Toll Restriction. PBX Access
Codes can be up to 2 digits, using
0-9, #, * and LINE KEY 1 (don’t
care). When using Account Codes,
do not use an asterisk within a
PBX access code. Otherwise, after
the *, the trunk would stop sending
digits to the central office. Entries
1-4 correspond to the 4 PBX
Access Codes. Each code can
have up to 2 digits.
09 Specific Dial
Outgoing Code
1
~20
Dial
(Up to 8 digits)
No Setting
10 Outgoing Call
Code Setup
1
~20
Dial
(Up to 4 digits)
No Setting
Input Data
Item
No.
Item Table Input Data Default Description