NEC ELECTRA ELITE IPK II - CO;PBX DIALING OPTIONS; Save Number Dialed

Electra Elite IPK II Document Revision 1
Programming 1 - 3
SECTION 4 HOW TO EXIT PROGRAMMING MODE
To exit the programming mode:
When you are done programming, you must be out of a program’s options to exit
(pressing the Answer key will exit the program’s option).
1. Press Answer key to exit the program’s options, if needed.
2. Press Speaker. If changes were to the system programming, "Saving System
Data" is displayed.
3. The display shows "Complete Data Save" when completed and exits the
telephone to an idle mode.
 To save a customer’s database, a blank Compact Flash (CF) is required. Insert the CF
into the CPUII and, using Program 90-03, save the software to the Compact Flash.
(Program 90-04 is used to reload the customer data if necessary.) Note that a Compact
Flash can only hold one customer database. Each database to be saved will require its
own separate card.
Password
User
Name
Level Programs at this Level
47544 necii 1 (MF) Manufacturer (MF):
All programs
12345678 tech 2 (IN)
Installation (IN):
All programs in this section not listed below for SA and
SB
0000 ADMIN1 3 (SA) System Administrator - Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09,
15-10, 15-11, 20-16, 21-07, 21-14, 22-04, 22-11, 25-08,
30-03, 32-02, 40-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 90-03, 90-04, 90-06, 90-07,
90-18, 90-19
9999 ADMIN2 4 (SB) System Administrator - Level 2 (SB):
13-04, 13-05, 13-06
Program Mode
Base Service OP1 OP2