NEC ELECTRA ELITE IPK II - Page 275

Document Revision 1 Electra Elite IPK II
2 - 240 Program 22 : Incoming Call Setup
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
, Enter characters:
, + , - . / : ; < = > ? B E σ S ∞ ¢
£
# # = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space.
(In system programming mode, use the right arrow soft key instead to
accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the
right.
Input Data
Conversion Table Number 1~2000
Item
No.
Item Input Data Default
01
Received Number
Maximum 8 digits No Setting
02
Target Number
Maximum 24 digits No Setting
03
DID Name
Maximum 12 characters No Setting
04
Transfer Operation Mode
0 = No Transfer
1=Busy
2=No Answer
3=Both
0
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can be up to 12 digits
long.
Use this keypad digit . . . When you want to. . .