NEC ELECTRA ELITE IPK II - Page 346

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 311
Default
Item 01 : Internal Paging Group Name
# # = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the
right.
Input Data
Internal Paging Group Number 01~64
Item
No.
Item Input Data Default Description
01
Internal Paging
Group Name
Up to 12 Characters
See
default
table
below
Assign names to Internal Paging Groups
(i.e., Page Zones). The system shows
the names you program on the
telephone displays.
02
Internal Paging
Splash Tone
0 = Ordinary Volume
(Normal)
1 = Mute
2 = No Tone (None)
0
Allow an extension to have normal (0),
muted (1) or no (2) Internal Paging alert
beeps before a Paging announcement.
Extension
Paging Group
Name
01 Group 1
02 Group 2
::
64 Group 64
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can be up to 12
digits long.
Use this keypad
digit . . .
When you want to. . .