NEC ELECTRA ELITE IPK II - Page 375

Document Revision 1 Electra Elite IPK II
3 - 340 Program 35 : SMDR Account Code Setup
07
Toll Charge Cost
Set this option to (1) have the SMDR report
include toll charges.
0 = Not Displayed
1 = Displayed
1
08
Incoming Call
Enable this option (1) to have the SMDR report
include incoming calls. If you disable this option
(0), incoming calls will not print.
0 = Not Displayed
1 = Displayed
1
09
Extension Number or Name
Set this option (1) to have the SMDR report
include extension numbers. Set this option (0)
to have the SMDR report include extension
names.
0=Name
1=Number
1
10
All Lines Busy (ALB) Output
Determine if the All Lines Busy (ALB) indication
should be displayed.
0 = Not Displayed
1 = Displayed
0
11
Walking Toll Restriction Table Number
0 = Not Displayed
1 = Displayed
1
12
DID Table Name Output
Determine if the DID table name should be
displayed.
0 = Not Displayed
1 = Displayed
0
13
CLI Output When DID to Trunk
Determine if the CLI output should be displayed
for DID.
0 = Not Displayed
1=Displayed
0
14
Date
Determine whether the date should be
displayed on SMDR reports.
 This option must be set to “0” if the trunk
name is set to be displayed in Program
35-02-03.
0 = Not Displayed
1 = Displayed
0
15
CLI / DID Number Switching
Determine if the CLI/DID Number Switching
should be displayed.
0=CLI (CLIP)
1 = DID Calling
Number
0
16
Trunk Name or Received Dialed Number
Determine how the SMDR should print
incoming calls on ANI/DNIS or DID trunks. If set
to (1), ANI/DNIS trunks can print DNIS digits. If
set to (0) trunk names are printed instead.
0 = Trunk Port
Name
1 = Received
Dialed Number
0
17
Print Account Code or Caller Name of
Incoming Call
Determine if SMDR should print Account Code
or Caller Name of Incoming Call.
0=ACC
1=CNAME
0
Item
No.
Item Input Data Default