NEC ELECTRA ELITE IPK II - Page 456

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 421
10
Forced Unscreened Transfer
(Forced UTRF)
Use this option to enable or disable Automated
Attendant Forced Unscreened Transfer for the
Subscriber Mailbox. If enabled, each Screened
Transfer (TRF) to the extension is converted to an
Unscreened Transfer (UTRF). If disabled, Screened
Transfers from the Automated Attendant occur
normally.
0 = No (Disabled)
1 = Yes (Enabled)
0 (No - Disabled)
11
Auto Time Stamp
(Auto Time Stamp)
Use this option to enable or disable Auto Time
Stamp for the Subscriber Mailbox. If enabled, after
the subscriber listens to a message IPK II In-Mail will
announce the time and date the message was left.
Auto Time Stamp will also announce the message
sender (if known).
A subscriber can also enable Auto Time Stamp from
their mailbox.
0 = No (Disabled)
1 = Yes (Enabled)
0 (No - Disabled)
12
System Administrator
(System Admin)
Use this option to designate the Subscriber Mailbox
as a System Administrator. This allows the
subscriber to use the SA options after logging onto
their mailbox.
0 = No (Disabled)
1 = Yes (Enabled)
Mailbox 1 (101) =
Enabled (1)
All other
mailboxes =
Disabled (0)
13
Dialing Option
(Dialing Option)
Dialing Option provides additional dialing options for
Next Call Routing Mailbox calls (see Next Call
Routing Mailbox below). If enabled, a caller who
accesses the Subscriber Mailbox to leave a
message can dial any of the options in the Next Call
Routing Mailbox’s Dial Action Table. If disabled, the
caller can only dial 0 (to use the Next Call Routing
Mailbox’s 0 action).
0 = No (Disabled)
1 = Yes (Enabled)
0 (No - Disabled)
14
Next Call Routing Mailbox
(Next CR Mbox)
Use this option to assign a Next Call Routing
Mailbox to the Subscriber Mailbox. This provides
callers with additional dialing options while listening
to a Subscriber Mailbox recorded or default greeting.
The digits the caller can dial depends on the setting
of the Next Call Routing Mailbox and Alternate Next
Call Routing Mailbox options.
Call Routing
Mailbox Number
(1~3 digits, 01~016)
No entry (Entered
by pressing CLEAR)
1 (Call Routing
Mailbox 01)
By default, Call
Routing Mailbox
numbers are
01~08.
15
Directory List 0 = None
1~8 = List Number
, = All
0 (None)
Input Data
Item
No.
Item Input Data Default