Nordson freedom - Modifying Applicator or Hose Zone Names

Setup
4-14
Part 1123087_02
 3/2014 Nordson Corporation
Modifying Applicator or Hose Zone Names
Follow this procedure to enter a custom name for an applicator or a hose
heated zone.
1.. From the Home screen, touch an applicator zone button (Zone 1B,
Zone2B, Zone 3B, or Zone 4B) or a hose zone button (Zone 1A,
Zone2A, Zone 3A, or Zone 4A).
2.. Touch Create/Modify Name and use the keypad to enter a custom
name for the selected zone. Refer to Table 4‐3 for default and optional
settings.
3.. Touch Done.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
On
System Status:
Ready/OK
175C
Zone 4B
175C
175C
Zone 2A
175C
175C
Zone 4A
175C
Recipes:
Nothing Loaded
System Status:
Ready/OK
Create/Modify NameAdjust Setpoint
Zone State: Enabled
Done
Zone 1B
Zone 1B
EcoBead Settings
175C
Ready
Figure 4‐6 Accessing an applicator or hose zone screen (Zone 1B screen shown)
Table 4‐3 Applicator and Hose Zone Name Default and Optional Settings
Button Description Default Setting Optional Settings
Create/Modify Name Specifies the default or
custom name for the selected
zone
Applicator 1: Zone 1B
Applicator 2: Zone 2B
Applicator 3: Zone 3B
Applicator 4: Zone 4B
Hose 1: Zone 1A
Hose 2: Zone 2A
Hose 3: Zone 3A
Hose 4: Zone 4A
Limited to 10
visible characters