Nordson freedom - Switching On;Off Heaters, Scheduler, or Refill

Operation
5-22
Part 1123087_02
 3/2014 Nordson Corporation
Switching On/Off Heaters, Scheduler, or Refill
You can switch the heaters, the fill system, or the scheduler On or Off from
the Master Controls screen.
See Figure 5‐11.
1. From the Home screen, touch Master Controls.
2. Touch the appropriate button to switch On/Off or enable/disable the
following:
 Heater Control
 Scheduler
 Refill
Refer to Table 5‐2 for the meaning of the button colors.
NOTE: When the fill system is enabled, it automatically switches on
when the system status is Ready/OK. The fill system automatically
switches Off when the heaters are switched Off or when the melter exits
Ready/OK status.
NOTE: If a fault occurs, Pump Control and Heater Control automatically
switch Off.
3. Touch Done.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
Ready
System Status:
Ready/OK
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Recipes:
Nothing Loaded
Pump
Ready
System Status:
Ready/OK
Done
Scheduler
Pump Control
Heater Control
Standby
Settings System
Scheduler: Off
Pump: OnHeaters: On
Standby: Off
Refill
Disabled
Master Controls
Ready
Figure 5‐11 Accessing the Master Controls screen