Nordson freedom - Resetting the Service Interval

Operation
5-26
Part 1123087_02
 3/2014 Nordson Corporation
Resetting the Service Interval
When the heaters have been on for longer than the user‐specified number of
hours (default 500), a pop-up message appears and the system status
indicates Ready/Service.
NOTE: To enter a custom Service Reminder message, refer to Entering a
Custom Service Alert in Section 4, Setup.
There are two ways to clear or reset the service interval value:
 From the Service Reminder pop-up message
 From the Service Reminder screen
To clear or reset the service interval from the pop‐up message
Touch Result
OK Closes the pop-up message, but the service
reminder condition still exists.
The System Status button continues to indicate
Ready/Service.
Clear Closes the pop-up message and resets the
service reminder counter back to 0 (zero) hours.
Nordson Corporation recommends choosing this
selection after the required service has been
performed.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
Ready
System Status:
Ready/OK
The heaters have been on for more than 500 hours. Melter is working, but maintenance
required.
Service Reminder
OK Clear
Ready
Figure 5‐14 Service Reminder message