Nordson freedom - Starting the System

Melter power switch
Operation
5-4
Part 1123087_02
 3/2014 Nordson Corporation
Starting the System
1. Switch the melter on. The Home screen appears.
2. Wait until the System Status indication shows Ready/OK.
NOTE: If a value is entered for Ready Delay, the Ready Delay time must
elapse before the System Status indication shows Ready/OK.
Pump: Off
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
System Status:
Ready/OK
System Status
indication
Figure 5‐1 Location of the System Status indication on the Home screen