Nordson freedom - Displaying Diagnostics (the Event Log)

Administration
System
Master
Controls
Display/Save
Diagnostics
Troubleshooting
7-5
Part 1123087_02
 3/2014 Nordson Corporation
Displaying Diagnostics (the Event Log)
Follow this procedure to view an event log that contains useful
troubleshooting information. Refer to the next procedure, Obtaining Event
Log and Diagnostics Files to obtain event log and diagnostic files that you
can view on a computer and email to your Nordson Representative.
1. From the Home screen, touch Master Controls > System >
Administration > Display/Save Diagnostics.
NOTE: You can also view the event log by touching the System Status
button on the Home screen.
2. Select the event log you want to view:
 Complete Event Log—CEL
 Faults Only
 Alerts Only
 Parameter/Setpoint Changes.
The selected events are displayed in the Display/Save Diagnostics
screen.
Complete Event Log
Next
Cancel
Display/Save Diagnostics
Home
Faults Only
Warnings Only
Parameters / Set Point
Changes
Back
Done
Display/Save Diagnostics
Save File
05/04/12 11:52:20 Event Ready enter
Source: System Status: OK
Zone/Parameter: 0 Zone/Sub-code: 0
05/04/12 11:50:50 Event Ready enter
Source: System Status: OK
Zone/Parameter: 0 Zone/Sub-code: 0
05/04/12 11:40:03 Event Zone control off
Source: HMI Status: OK
Zone/Parameter: 17 Zone/Sub-code: 0
05/04/12 11:34:29 Event Ready enter
Source: System Status: OK
Zone/Parameter: 0 Zone/Sub-code: 0
Old value: 1 New value: 0
Home
Figure 7‐4 Display/Save Diagnostics screens