Nordson freedom - Resetting the System

Administration
System
Master
Controls
Troubleshooting
7-4
Part 1123087_02
 3/2014 Nordson Corporation
Resetting the System
Follow this procedure to reset editable settings to their factory defaults as
shown in Table 7‐1. Any customized settings will need to be re‐entered.
1. From the Home screen, touch Master Controls > System >
Administration > System Reset.
2. Touch Parameters only or Parameters and custom names. Refer to
Table 7‐1 for the an explanation of the system reset levels.
NOTE: Recipes and event log data are not deleted when a system reset
is performed.
NOTE: The first time the melter is switched on after a factory reset,
Heater Control is Off. For all other times the melter is switched on, Heater
Control is On, regardless of whether it was On or Off when the melter was
switched off.
3. Touch Done.
Done
System Reset
Home
Parameters only
Parameters and custom names
Level 1
Level 2
Figure 7‐3 System Reset screen
Table 7‐1 Levels of System Reset
Button Description
Parameters only Resets editable parameters such as setpoints,
but leaves custom zone names intact
Parameters and
custom names
Resets all editable parameters, including
custom zone names