Nordson freedom - Connect to a Multi-Feed Adhesive Storage Bin

Installation
3-49
Part 1123087_02
 3/2014 Nordson Corporation
Connect to a Multi-Feed Adhesive Storage Bin
To install the sequencer
1. See Figure 3‐35. Mount the sequencer and bracket (2) in the desired
location.
2. Connect a customer‐supplied power supply to the sequencer as follows:
a.. Select a suitable power cable rated for the 100-240 VAC input
required by the sequencer. Ensure that the power cable meets
applicable electrical codes and standards.
b.. See Figure 3‐32. Remove the sequencer cover (1) and touch
guard(2).
c.. Route the power cable through the strain relief (4) and connect the
power cable leads to the L1, L2/N, and PE/G terminals (3).
d.. Reinstall the sequencer touch guard and cover.
1
2
3
4
Figure 3‐32 Connecting a power supply to the sequencer
1. Cover
2. Touch guard
3. Power supply terminals
4. Power supply cable strain
relief