Nordson freedom - Enabling;Disabling Zones or Changing Temperature Setpoints

Operation
5-18
Part 1123087_02
 3/2014 Nordson Corporation
Enabling/Disabling Zones or Changing
Temperature Setpoints
Touch any heated zone button to:
 Enable or disable the zone
 Adjust the temperature setpoint
Refer to Table 5‐2 for the meaning of the button colors.
NOTE: Changed settings are permanently stored approximately every two
minutes. If the system is switched off within two minutes after a setting is
changed, the change may not be saved.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
On
System Status:
Ready/OK
175C
Zone 4B
175C
175C
Zone 2A
175C
175C
Zone 4A
175C
Recipes:
Nothing Loaded
System Status:
Ready/OK
Create/Modify NameAdjust Setpoint
Zone State: Enabled
Done
Zone 1B
Zone 1B
EcoBead Settings
175C
Ready
Figure 5-9 Enabling/disabling a zone or changing a temperature setpoint