Nordson freedom - Entering or Modifying a Global Temperature Setpoint

Temperature
Settings
Master
Controls
Setup
4-22
Part 1123087_02
 3/2014 Nordson Corporation
Entering or Modifying a Global Temperature Setpoint
Follow this procedure to enter the same temperature setpoint for all heated
zones. To enter a specific temperature setpoint for an individual zone, refer
to Modifying Temperature Setpoints for Individual Zones.
NOTE: Nordson Corporation recommends calibrating the level sensor
whenever the grid (or global) temperature setpoint is changed by more than
25 °C (50 °F). Refer to Calibrating the Level Sensor in Section 7,
Troubleshooting.
1.. From the Home screen, touch Master Controls > Settings >
Temperature.
2.. Touch Global Setpoint or Global Temperature Change and use the
keypad to enter the desired value. Refer to Table4‐6 for an explanation
of these parameters and their default and optional settings.
3.. Touch Done.
Global Temperature ChangeGlobal Setpoint
Enabled
Done
Smart Melt
Temperature
175C
Home
Smart Melt Setpoint
175C
Temperature Limits
175C
Smart Melt Time
175C
Figure 4‐11 Temperature screen