Standby
Settings
Master
Controls
Zone Standby
Setup
4-36
Part 1123087_02
3/2014 Nordson Corporation
Zone Standby Setup
1.. From the Home screen, touch Master Controls > Settings > Standby >
Zone Standby.
2.. Touch Zone Standby Time and use the keypad to enter the desired
value. Refer to Table 4‐13 for an explanation of this parameter and the
default and optional settings.
3.. Touch Zone Standby to switch On Zone Standby.
4.. To re‐enable a hose or applicator zone that has entered zone standby,
touch the corresponding applicator or hose zone button, then touch the
enable/disable button. Refer to Enabling/Disabling Zones or Changing
Temperature Setpoints in Section 5, Operation for more information.
5.. Touch Done.
Zone Standby
Done
Home
Zone Standby Time
60 min.
On
Zone Standby
Individual zone standby is activated by monitoring applicator‐specific
signals on the EcoBead board.
Figure 4‐17 Zone Standby screen
To Next Page
Loading...
