Nordson freedom - EcoBead Capability Specifications

Technical Data
10-4
Part 1123087_02
 3/2014 Nordson Corporation
EcoBead Capability Specifications
Item Sub‐Item Specification
Hose interface board inputs
Number of inputs 4
Input voltage range 10-30 VDC (24 VDC nominal as
needed to actuate the solenoid)
Input LED indicators 8 (4 on EcoBead board, 4 on hose
interface board)
Connection type Two‐piece terminal block (X4 on
hose interface board, keyed)
Hose interface board outputs
Number of outputs 4
NOTE: There are four channels,
but each channel can output from
two connectors.
Output voltage range 10–30 VDC
Output current rating 1.2 A
Output switch type High‐side switching
System power available to
solenoid
None
NOTE: The applied input signal
to the solenoid is switched. The
signal must be capable of driving
the intended solenoid.
Output LED indicators 8 (4 bicolor on EcoBead board, 4
on hose interface board)
Connector for standard output Located at applicator end of hose
Connector for alternate output Two‐piece terminal block (X1 on
hose interface board, keyed)
Control system functions
Maximum operating frequency 150 Hz (9000 per minute)
Minimum on time 5 ms
Line speed sensor Not required
Diagnostic and status LED
indicators
Multiple
NOTE: Refer to Section 7,
Troubleshooting, for detailed
information.