Operation
5-3
Part 1123087_02
3/2014 Nordson Corporation
Filling the Adhesive Storage Bin
Before filling the adhesive storage bin, confirm that the hot melt material is
compatible with the melter. Refer to Limitations of Use in Section 2,
Description, for information about hot melt materials that should not be used
in Freedom melters.
The melter is equipped with a level sensor. When the level sensor detects a
low level of adhesive in the grid, it calls for adhesive to activate the fill
system.
To fill the adhesive storage bin
CAUTION! Keep the adhesive supply free of contaminants.
1. Observe the level of adhesive in the bin through the bin window. If the
adhesive level is low, continue with this procedure to add adhesive.
2. Open the adhesive storage bin lid.
3. Pour adhesive into the bin until the level is just below the top.
NOTE: An optional adhesive storage bin grate for the top of the bin is
available. Pouring packaged adhesive through a grate sifts the adhesive
and separates any clumps caused by the adhesive packaging process.
Refer to Adhesive Storage Bin Grates in Section 9, Parts.
4. Close the lid and keep it closed during system operation.
To Next Page
Loading...
