Nordson freedom - About Heated Components (contd)

Operation
5-2
Part 1123087_02
 3/2014 Nordson Corporation
About Heated Components (contd)
The control system uses the default names shown in Table 5‐1 to identify the
external heated zones. The default names for these zones can be changed
(refer to Modifying Applicator or Hose Zone Names in Section 4, Setup).
Table 5‐1 Applicator and Hose Zone Default Names
Heated Zone Default Name
Applicator 1 Zone 1B
Applicator 2 Zone 2B
Applicator 3 Zone 3B
Applicator 4 Zone 4B
Hose 1 Zone 1A
Hose 2 Zone 2A
Hose 3 Zone 3A
Hose 4 Zone 4A