Nordson freedom - Starting;Stopping the Pump

Operation
5-16
Part 1123087_02
 3/2014 Nordson Corporation
Starting/Stopping the Pump
If the pump is not set up to start automatically, use this procedure to start the
pump. Use this procedure also to stop the pump at any time, even if the
pump was started automatically or by a remote input.
NOTE: When the pump is On, it attempts to pump even if the system status
is not Ready/OK. Nordson Corporation recommends not starting the pump
until the system status is Ready/OK.
NOTE: To set up the pump to automatically start after all zones have
reached setpoint temperature, refer to Selecting the Auto Pump Setting in
Section 4, Setup.
1. From the Home screen, touch the Pump button.
2. Touch Pump Control to switch On/Off the pump.
Refer to Table 5‐2 for the meaning of the button colors.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
On
System Status:
Ready/OK
Recipes:
Nothing Loaded
System Status:
Ready/OK
Purge
Auto Pump
OffPump: On
Done
Pump Control
Pump
Off
Ready
Figure 5‐8 Accessing the Pump Control button