Nordson freedom - Automatic Standby;Auto Heaters Off Time Setup

Standby
Settings
Master
Controls
Automatic Standby
Setup
4-39
Part 1123087_02
 3/2014 Nordson Corporation
Automatic Standby/Auto Heaters Off Time Setup
1.. Connect wiring to supply 24 VDC to input 1. Refer to Connect
Inputs/Outputs (Optional) in Section3, Installation.
2.. Make sure the input 1 control option is set to Automatic Standby. Refer to
Setting Up Inputs/Outputs in this section.
3.. From the Home screen, touch Master Controls > Settings > Standby >
Automatic Standby.
4.. Touch Automatic Standby Start Time and/or Auto Heaters Off Time
and use the keypad to enter the desired values. Refer to Table 4‐15 for
an explanation of these parameters and their default and optional setting.
5.. Touch Automatic Standby to enable Automatic Standby.
6.. Touch Done.
Automatic Standby
Done
Home
Auto Standby Start Time
60 min.
Auto Heaters Off Time
60 min.
Enabled
Automatic Standby
Figure 4‐19 Automatic Standby screen