Nordson freedom - Setting Up Inputs;Outputs

Input
(or Output)
Settings
Master
Controls
Setup
4-42
Part 1123087_02
 3/2014 Nordson Corporation
Setting Up Inputs/Outputs
The melter is equipped with four standard user‐configurable inputs and three
standard user‐configurable outputs. Inputs/outputs are customer‐wired to the
melter and then set up through the touchscreen to provide one of the control
options shown in Tables 4‐16 and 4‐17.
NOTE: Refer to Connect Inputs/Outputs (Optional) in Section 3, Installation,
for wiring instructions.
1.. From the Home screen, touch Master Controls > Settings > Input or
Output.
2.. Touch the button for the input or output you want to change and select
the desired control option. Refer to Tables 4‐16 and 4‐17 for the default
and optional settings.
3.. To reverse the logic of an output, touch the Invert button next to the
output. The button color changes to blue.
4.. Touch Done.
Input
Status
Input 1
Done
Home
Input 2
Input 3
Automatic Standby
Standby
Heater Control
Input 4
Pump Control
Output 1
Done
Output
Home
Output 2
Output 3
System Ready
Fault
Ready - Pump On
InvertStatus
Output 1
Done
Home
Output 2
Output 3
System Ready
Fault
Ready - Pump On
Figure 4‐20 Input and Output screens