Operation
5-1
Part 1123087_02
3/2014 Nordson Corporation
Section 5
Operation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Introduction
Operation of the hot melt system includes keeping the adhesive bin filled,
starting and stopping the system, and monitoring the system. Other
frequently used procedures are also provided in this section.
About Heated Components
The hot melt system includes two groups of heated components that are
referred to as internal and external heated zones.
The internal heated zones are the
Grid
Manifold
The external heated zones are the
Hoses
Applicators
To Next Page
Loading...
