Nordson freedom - Calibrating the Touchscreen

Display
System
Master
Controls
Troubleshooting
7-13
Part 1123087_02
 3/2014 Nordson Corporation
Calibrating the Touchscreen
Follow this procedure to improve the accuracy of your interaction with the
touchscreen.
1. From the Home screen, touch Master Controls > System > Display >
Calibrate Screen.
NOTE: If the Calibrate Screen button is not accessible, refer to
Touchscreen Troubleshooting Table later in this section.
2. Touch the center of the four + symbols to calibrate the touchscreen. After
touching the last +, allow at least 5 seconds for the software to respond.
NOTE: Use caution when calibrating the touchscreen because the
calibration can easily be skewed. Nordson Corporation recommends
using a stylus or the eraser end of a pencil when calibrating the
touchscreen.
3. Touch Done.
Brightness/Contrast
Done
Home
Display
Screen Saver Delay
Calibrate Screen
Wipe Display
Calibrate Screen
Figure 7‐11 Calibrating the display screen