System
Master
Controls
Troubleshooting
7-12
Part 1123087_02
î 3/2014 Nordson Corporation
Locking Out Communication
Use Lockout Communications to prevent unexpected operational changes
from any remote source (such as the standard inputs) from being
communicated to the melter control system. Nordson Corporation
recommends using Lockout Communication when it is necessary to perform
service procedures inside the melter that require the power to remain on.
1. From the Home screen, touch Master Controls > System >
Administration.
2. Touch Lockout Communication to switch it On or Off.
3. Touch Done.
Lockout Communication
Recipes
Display/Save Diagnostics
Done
System Reset
Administration
Display System DataReset Password
Home
Engineering
Off
Figure 7â10 Administration screen
To Next Page
Loading...
