Contents of the adhesive filter
service kit:
Adhesive filter
Disabled
Refill
Master
Controls
Maintenance
6-6
Part 1123087_02
3/2014 Nordson Corporation
Replacing the Adhesive Filter
You will need the following items:
Adhesive filter service kit
5‐mm hex key
13‐mm wrench or adjustable wrench
Small waste container
Refer to Section 9, Parts, for service kit part numbers.
To remove the adhesive filter
1. Relieve system pressure. Refer to Relieving System Pressure earlier in
this section as needed.
2. From the Home screen, touch Master Controls > Refill to disable the fill
system.
3. Remove the hydraulics cover. Refer to Removing or Installing Covers
earlier in this section as needed.
4. See Figure 6‐3. Use a 13-mm wrench or an adjustable wrench to close
the shutoff valve.
Closed
Open
Figure 6‐3 Location of the shutoff valve
To Next Page
Loading...
