Repair
8-51
Part 1123087_02
3/2014 Nordson Corporation
5. Using a PC or laptop with an SD card reader/writer, copy the *.dat to the
top level directory (root directory) on the customer SD card.
6. Reinstall the customer SD card.
7. Close the touchscreen assembly as follows:
a.. Lift the assembly up, push it back towards the chassis, and then let it
drop onto the pins.
b.. Tighten the screws loosened previously.
8. Restore power to the system and switch the melter on. The system
automatically detects a new *.dat file and does the following:
Performs an upgrade by copying the current *.dat file to the \backup
directory on the internal SD card. A pop‐up shows the file transfer
progress.
Automatically reboots the melter when the upgrade is complete
(usually in about 10 minutes)
NOTE: Nordson Corporation recommends copying the *.dat files to
another backup storage media in case an SD card is damaged.
To Next Page
Loading...
