Nordson freedom - Page 4

Table of Contents
ii
Part 1123087_02
 3/2014 Nordson Corporation
Installation 3-1.................................................
Overview 3‐1..................................................
Experience of Installation Personnel 3‐1............................
Melter Installation 3‐2...........................................
Obtain Customer‐Supplied Materials 3‐2........................
Select the Installation Location 3‐2.............................
Verify the Contents of the Ship‐With Kit 3‐4......................
Mount the Melter 3‐6.........................................
Unpacking the Melter 3‐6...................................
Mounting the Melter on a Vertical Surface 3‐8..................
Mounting the Melter on the Floor Stand 3‐10....................
Mounting the Melter on the Bench Stand 3‐14...................
Configure the Electrical Service 3‐19.............................
Connect the Driver, Pattern Controller, or Timer Wiring 3‐24.........
Connect Applicator Signal Wiring 3‐26...........................
Connect Inputs/Outputs (Optional) 3‐32..........................
Connect a Fill System Status Output (Optional) 3‐34...............
Connect an Air Supply to the Melter 3‐36.........................
Connect Hoses and Applicators 3‐39............................
Remove the Shipping Bolt 3‐43.................................
Fill System Installation 3‐44.......................................
Connect to a Single‐Feed Adhesive Storage Bin 3‐44..............
Connect to a Multi-Feed Adhesive Storage Bin 3‐49................
Control System Setup and Initial System Startup 3‐54.................