Nordson freedom - Page 6

Table of Contents
iv
Part 1123087_02
 3/2014 Nordson Corporation
Operation 5-1..................................................
Introduction 5‐1................................................
About Heated Components 5‐1...................................
Filling the Adhesive Storage Bin 5‐3...............................
Starting the System 5‐4.........................................
Monitoring the System 5‐6.......................................
On/Off Button Colors 5‐6......................................
General System Status 5‐8....................................
Fill System Status 5‐10.........................................
Heated Zone Status 5‐12.......................................
Pump Status 5‐14.............................................
Starting/Stopping the Pump 5‐16..................................
Monitoring and Adjusting the Pump Air Pressure 5‐17.................
Enabling/Disabling Zones or Changing Temperature Setpoints 5‐18....
Switching On/Off Standby 5‐20....................................
Switching On/Off Manual Standby 5‐20...........................
Switching Off Automatic Standby 5‐20...........................
Switching Off Zone Standby 5‐20................................
Switching On/Off Heaters, Scheduler, or Refill 5‐22...................
Enabling/Disabling the EcoBead Capability 5‐23.....................
Clearing or Resetting Alerts/Faults 5‐24.............................
Resetting the Service Interval 5‐26.................................
Shutting Down 5‐28..............................................
Maintenance 6-1...............................................
Preventive Maintenance Schedule 6‐1.............................
Cleaning the Touchscreen 6‐2....................................
Relieving System Pressure 6‐3...................................
Removing or Installing Covers 6‐4................................
Replacing the Adhesive Filter 6‐6.................................
Replacing the Cyclone Exhaust Filter 6‐8..........................
Upgrading the Firmware 6‐9......................................
Upgrading the Firmware by Installing a New Customer SD Card 6‐9.
Upgrading the Firmware Electronically (File Only) 6‐11.............
Reverting Back to a Previous Firmware Version 6‐12...............