#
DescriptionArea
Protected area (must remain unprinted)1
Code segment 12
Code segment 23
Requirements
A sensor may require calibration for data integrity marks when a different developer station
or a different color is used. A message to this effect will be displayed on the operator
panel.
Requirements for sensor calibration for data integrity marks:
■
The user rights are available for this menu
■
The access ticket for this operator panel is requested
■
The printing system is in the 'Stop' status
■
No replacement function is being executed.
To Calibrate a Data Integrity Mark Sensor
#
Proceed as follows:
Click on the 'Configuration' -> 'Print parameters' -> 'Data integrity' -> 'Cali-
brate sensor' menu.
The 'Calibrate sensor' menu page opens.
1.
Select settings:
■
depending on the message, 'Automatic' or 'Specify mark'
■
depending on the message, 'Upper sensor' or 'Lower sensor'
Click the 'Next' button.
The necessary work steps are displayed.
For information on the icons displayed on the operator panel under 'Steps':
see ‘Explanation of icons’ on page 134.
Each step is described in more detail under 'Details'.
2.
Chapter 6 - Operating the Printing System258
Calibrating the Data Integrity Mark Sensor
To Next Page
Loading...
