Proceed as follows:
Clean the following with a vacu-
um cleaner and dry cloth:
■
Unclamp plate for the aut-
ofeed clamp
■
Paper brake
■
Pre-centering
7.
Push the paper input rocker
down until it latches.
8.
Complete cleaning the paper input on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
9.
Chapter 7 - Cleaning the Printing System 285
Cleaning the Paper Input
To Next Page
Loading...
