Oce ColorStream - Page 375

Proceed as follows:
Close all doors on the left-hand side of the printing system.16.
On the operator panel, enter whether a new photoconductor belt has been in-
serted and a new photoconductor blade used:
■
When you click the 'Yes' button:
The message on the operator panel is automatically deleted, the replacement
of the photoconductor belt and the photoconductor blade is documented
in the 'Consumable history' menu, and the consumables counter is reset.
■
When you click the 'No' button:
The consumables counter is not reset.
17.
#
Proceed as follows:
On the operator panel, enter whether the belt is to be run in:
■
When you click the 'Yes' button:
The printing system remains in the 'Special functions' status. The belt can
be run in immediately afterwards (see ‘Running in a Belt’ on page 411).
■
When you click the 'No' button:
All printing system assemblies are checked (duration approx. two minutes)
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
18.
Chapter 9 - Replacing Expendables 375
Inserting a Photoconductor Belt in the Lower Print Unit