On the operator panel, enter whether the transfer belt is to be run in:
■
When you click the 'Yes' button:
The printing system remains in the 'Special functions' status. The belt can
be run in immediately afterwards (see ‘Running in a Belt’ on page 411).
■
When you click the 'No' button:
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
7.
Chapter 9 - Replacing Expendables410
Inserting the Transfer Belt in the Lower Print Unit
To Next Page
