Proceed as follows:
Remove the change receiver with
the corotron wire with an up-
ward motion.
6.
Remove all other corotron wires from the corotron slide-in unit with the change
receiver (repeat from step 3 in each case).
7.
Caution
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber
nozzle and filter set for fine dust. For larger toner quantities, the industrial
vacuum cleaner must be explosion proof.
Vacuum out the empty corotron
slide-in unit.
8.
Also vacuum out any visible dirt
from the other side of the
corotron slide-in unit.
Other parts of the corotron slide-
in unit must not be cleaned.
9.
Chapter 9 - Replacing Expendables430
Replacing corotron wire
To Next Page
Loading...
