Oce ColorStream - Page 453

Proceed as follows:
Complete the replacement of the cleaning felt on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All aggregates of the printing system are inspected (duration around two
minutes), before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
16.
Chapter 9 - Replacing Expendables 453
Replacing the cleaning felt