Proceed as follows:
Insert the two cooling fins
shown:
First insert on the right-hand
side (in paper path direction)
and then press downwards on
the left-hand side (in paper path
direction).
4.
Caution
Observe the sensors
The paper web must be inserted below the sensors.
Fold back the paper web and
carefully push it through the pa-
per output.
In doing so insert the paper web
below the sensors.
5.
Affix the paper web with any
popular adhesive (for example,
Scotch ATG 700). Make sure
that the offset of the reference
edge is minimal (< 1mm / <
0.04"), and that the edge is as
flush as possible. Depending on
the utilized paper, either:
■
affix to the stack (1),
■
or affix overlapping (2). Al-
ways fold back the projecting
edge of an overlap so that it
cannot cause a jam.
6.
Chapter 9 - Replacing Expendables 463
Installing smoothing rollers
To Next Page
Loading...
