Safety 1-3
AC30V series Variable Speed Drive
WARNING! - Ignoring the following may result in injury or damage to equipment
SAFETY
Where there is conflict between EMC and Safety requirements, personnel safety shall always take precedence.
• Never perform high voltage resistance checks on the
wiring without first disconnecting the drive from the circuit
being tested.
• Whilst ensuring ventilation is sufficient, provide guarding
and /or additional safety systems to prevent injury or
damage to equipment.
• When replacing a drive in an application and before
returning to use, it is essential that all user defined
parameters for the product’s operation are correctly
installed.
• All control and signal terminals are SELV, i.e. protected by double
insulation. Ensure all external wiring is rated for the highest system
voltage.
• Thermal sensors contained within the motor must have at least
basic insulation.
• All exposed metalwork in the Inverter is protected by basic
insulation and bonded to a safety earth.
• RCDs are not recommended for use with this product but, where
their use is mandatory, only Type B RCDs should be used.
EMC
• In a domestic environment this product may cause radio
interference in which case supplementary mitigation
measures may be required.
• This equipment contains electrostatic discharge (ESD)
sensitive parts. Observe static control precautions when
handling, installing and servicing this product.
• This is a product of the restricted sales distribution class according
to IEC 61800-3. It is designated as “professional equipment” as
defined in EN61000-3-2. Permission of the supply authority shall be
obtained before connection to the low voltage supply.
WARNING! – Control Unit Removal / Fitting
Isolate supply before plugging or unplugging control unit to the power stack.
To Next Page
Loading...
Need help?
General
