Setup Wizard 9-5
AC30V series Variable Speed Drive
The time that the Drive will take to ramp the setpoint from 0.00% to 100.00%
when Ramp Type is LINEAR.
The time that the Drive will take to ramp the setpoint from 100.00% to 0.00%
when Ramp Type is LINEAR.
Selects stopping mode that the controller will use once the run command has
been removed when in Volts/Hertz control mode, (induction motor only).
Selects stopping mode that the controller will use once the run command has
been removed when in Sensorless Vector or Closed Loop Vector control mode.
Selects the Volts to Frequency curve.
Selects the drive rating. Affects the ratio of nominal current compared with
maximum overload current.
To Next Page
Loading...
