Parker AC30 series User Manual

9-6 Setup Wizard
AC30V series Variable Speed Drive
Fieldbus Options
This section is only shown if a communications option is fitted.
PNO
Parameter
Comment
0044
Comms Required
This defaults to match the communications option that is fitted. If no option is required select NONE. Selecting
a different option will result in a configuration error.
These parameters are shown when the CANopen option is fitted.
PNO
Parameter
Comment
0044
Comms Required
CANOPEN
Refer to CANopen Technical Manual HA501841U001
0212
CANopen Node Address
●
0213
CANopen Baud Rate
●
0048
Comms Trip Enable
●
These parameters are shown when the DeviceNet option is fitted.
PNO
Parameter
Comment
0044
Comms Required
DEVICENET
Refer to DeviceNet Technical Manual HA501840U001
0219
DeviceNet MAC ID
●
0220
DeviceNet Baud Rate
●
0048
Comms Trip Enable
●
These parameters are shown when the Ethernet IP option is fitted.
PNO
Parameter
Comment
0044
Comms Required
ETHERNET IP
Refer to EtherNet IP Technical Manual HA501842U001
0199
Address Assignment
●
0200
Fixed IP Address
●
0201
Fixed Subnet Mask
●
0202
Fixed Gateway Address
●
0203
Option Web Enable
●
0048
Comms Trip Enable
●
These parameters are shown when the Modbus RTU option is fitted.
PNO
Parameter
Comment
0044
Comms Required
MODBUS RTU
Refer to Modbus RTU Technical Manual HA501839U001
0229
Modbus Device Address
●
0230
Modbus RTU Baud Rate
●
0231
Parity And Stop Bits
●
0232
High Word First RTU
●
0233
Modbus RTU Timeout
●
0048
Comms Trip Enable
●
www.comoso.com

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485