PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 26: XLII SLIDE-OUT
PA1553
32
3. Glue 4 rubber bumpers (#790610) on the
awning window frame as per FIGURE 62.
FIGURE 62: SIDE BUMPERS
4. Place masking tape on the inside of the
frame as per FIGURE 63.
FIGURE 63: MASKING TAPE APPLICATION
5. Apply Sika 255 in the upper and lower frame
corner as per FIGURE 64.
FIGURE 64: SIKA 255 APPLICATION
6. Apply Sika Aktivator as per FIGURE 65.
7. Apply Sika 255 as per FIGURE 66
(triangular bead: 10mm width X 10mm high).
FIGURE 65 : AWNING WINDOW – SIKA AKTIVATOR
FIGURE
66: AWNING WINDOW – SIKA 255 APPLICATION
8. Install the awning window centered in the
opening. Press the window slightly. The
awning window must be kept closed.
9. While a helper is pressing on the window
from outside, install the awning window
clamping frame and tighten screws
according to the sequence shown in
FIGURE 67.
FIGURE
67 : CORRECT TIGHTENING SEQUENCE

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English