PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 07: TRANSMISSION
PA1225
10
Fluid loss with filter change only
When changing main and lube filters at
recommended intervals, approximate fluid loss
for each filter as follows:
Main filter = 2 quarts (1.9 liters)
Lube filter =8 quarts (7.6 liters)
Refilling Transmission
The amount of refill fluid is less than the amount
used for the initial fill. Fluid remains in the
external circuits and transmission cavities after
draining the transmission.
NOTE
Quantities listed above are approximations and
do not include external oil cooler lines.
Using the oil level dipstick filler tube, refill with
24 US qts (23 liters) [28 US qts (26.5 liters) if
equipped with retarder] and check the oil level
using the Fluid Level Check Using
Pushbutton Shift Selector procedure in this
section.
4. INSTALLATION OF ALLISON TRANSMISSION BRACKETS
FIGURE 7: ALLISON TRANSMISSION BRACKETS 07133
5. ALLISON TRANSMISSION REMOVAL
The following procedure deals with the removal of
the Allison transmission without removing the
power plant cradle from vehicle. The methods
used to support the transmission and engine
depend upon conditions and available equipment.
1. Select transmission's "NEUTRAL" position,
apply parking brake, then set battery master
switch to the "OFF" position.
2. Jack up vehicle, then place safety supports
underneath body.
CAUTION
Only the recommended jacking points must be
used as outlined in Section 18, "BODY".

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English