PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 26: XLII SLIDE-OUT
PA1553
40
CAUTION
Never remove the structural reinforcement angle brackets inside the baggage compartments. Doing so
could lead to termination of the warranty coverage concerning the structural integrity.
20 CONVERSION CHECKLIST
The converter should check these points before closing the walls covering the roof reinforcing rod and the
pinions:
1. Check that the front slide-out exterior panels are parallel with the vehicle panels when retracted. If not, readjust
the tilt.
2. Check that the slide-out is straight when completely extended, and that it leans against all inner stoppers.
3. Make sure the vehicle upper member is parallel with the front slide-out structure. If not, readjust the roof
reinforcing rod. This may be affected by the loading on the roof.
4. Make sure the front slide-out lower member deflection is within 1/4". If not, redistribute the slide-out load.
5. Check the whole slide-out mechanism good functioning. The slide-out should retract and extend smoothly
without vibration.
Final check:
o Make sure the slide-out air pressure inlet valve is completely opened.
o Check the inflatable seal air pressure on the pressure regulator. The pressure should be 10 psi.

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English